處理器
擴大機
喇叭
超低音
配件
M FOUR 24V 定價NT＄17800
Small footprint 24 Volts 4-channel amplifier with integrated active crossover
 |
|---|
 |
 |
Product Speclflcation
M FOUR 24V
If you like to rev up your front and rear speakers, the M FOUR - 24V Edition will be exactly the right "tool" to do so. With generously 100 Watts RMS per channel into both 4 Ohms and 2 Ohms load this amp will heat up your voice coils in no time despite its super-compact dimensions. On the other hand the M FOUR - 24V Edition stays totally cool thanks to the highly efficient Class D design topology. 3-channel or 2-channel configurations are possible as well, delivering up to 2 x 200 Watts RMS of clean and undistorted output power.
Needless to say that the M FOUR - 24V Edition is equipped with a bunch of intelligent attributes like "start-stop capability" and our proprietary "ADEP" highlevel input so that it easily deals with all installation challenges of modern cars. Finally the extensive audio features will offer a sound quality at its best.
Features
-
Small footprint Class D amplifier with high output power of 100 Watts RMS @ 4 and 2 Ohms load
-
Start-Stop capability down to 12V supply voltage
-
Smart highlevel input with ADEP circuit (Advanced Diagnostics Error Protection) and Auto Turn-On function
-
Integrated, active crossover with highpass, lowpass and bandpass
-
“Input mode” switch for flexible input signal routing
-
SMD (Surface Mounted Device) manufacturing technology combines minimum space requirement with maximum reliability
-
Exclusive, extremely compact and clean design with illuminated HELIX-logo and low heat dissipation thanks to extraordinary efficiency
Speclflcation
Output power RMS / max.
- @ 4 Ohms
- @ 2 Ohms
- @ 1 Ohm
- bridged @ 4 Ohms
- bridged @ 2 Ohms
Max. output power per channel*
Amplifier technology
Inputs
Input sensitivity
Input impedance RCA / Cinch
Input impedance highlevel
Outputs
Output voltage RCA / Cinch
Signal converter for digital input
Frequency response
Bass boost
Highpass
Lowpass
Bandpass
Subsonic
Phase
Slope high- / lowpass
Slope subsonic / lowpass
Signal-to-noise ratio digital input
Signal-to-noise ratio analog input
Distortion (THD)
Damping factor
Operating voltage
Idle current
Fuse
Operating temperature range
Power rating
Additional features
Dimensions (H x W x D)
4 x 100 Watts
4 x 100 Watts
-
2 x 200 Watts
-
Up to 135 Watts RMS @ 2 Ohms
Class D
4 x RCA / Cinch
4 x Highlevel speaker input
1 x Remote In
RCA / Cinch 0.5 - 6 Volts
Highlevel 1.3 - 13 Volts
20 kOhms
9-33 Ohms
4 x Speaker output
-
-
10 Hz - 30,000 Hz
-
15 Hz - 250 Hz adjustable
40 Hz - 250 Hz adjustable
15 Hz - 50 Hz adjustable
-
-
12 dB/Oct.
-
-
98 dB (A-weighted)
0.05 %
100
18 - 36 Volts (max. 5 sec. down to 12 Volts)
550 mA
2 x 15 A Maxi-fuse (APX)
-40° C to +70° C
DC 24 V ⎓ 25 A max.
Active, adjustable crossover, input mode switch, Start-Stop capability, highlevel input with automatic turn on function and Advanced Diagnostics Error Protection (ADEP)
50 x 230 x 154 mm /
2.00 x 9.06 x 6.06”
Special features
Smart highlevel input
The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If a common amplifier will be hooked up failure messages and loss of specific features (e.g. fader function) quite often appear - but not with the M FOUR - 24V Edition.
The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.
Start-Stop capability
The switched power supply of the HELIX M FOUR - 24V Edition assures operation even if the battery’s voltage drops down to 12 Volts during engine crank.