top of page
brax-dsp.jpg

處理器

brax-verstaerker-amp.jpg

擴大機

brax-lautsprecher.jpg

喇叭

brax-subwoofer.jpg

​超低音

brax-zubehoer.jpg

​配件

MATRIX ML 10 SUB    定價NT$66000

250 mm High-End Subwoofer with 2 x 2 Ohms Dual Voice Coil

BRAX_MATRIX_ML10-SUB_Pers-Membran_1010x1
BRAX_MATRIX-ML10-SUB_Front-Membran_1277x
BRAX_MATRIX_ML10-SUB_Front-Magnet_1277x1
BRAX_MATRIX_ML10-SUB_Pers-Magnet_3640x31
brax.png

 

Product Speclflcation

MATRIX ML 10 SUB

 

The legendary BRAX MATRIX loudspeaker series – since many years the synonym for state-of-the-art sound quality is now completed with the ML10 SUB. Developed and manufactured just as uncompromisingly as all BRAX loudspeakers, this subwoofer is the acoustic benchmark against which it is to be measured.

Perfection meets maximum flexibility
Thanks to the use of the new 2 x 2 Ohms dual voice coil, the ML10 SUB enables most flexible connection configurations and therefore allows to achieve an extremely clean and maximally controlled bass reproduction easier than ever before. The separate voice coils with the four massive connection terminals allow three different configurations – 1 x 4 Ohms, 2 x 2 Ohms or 1 x 1 Ohm with an extraordinary maximum power handling up to 1,200 Watts.
 
MicroSphere – the perfect synthesis of weight and stiffness
One of the secrets of the BRAX ML10 SUB lies in its unique diaphragm, more precisely in its "MicroSphere" coating. It gives the hand-scooped cone the highest level of acoustic precision for an incomparable reproduction. This patented technology embeds ceramic hollow spheres with a diameter of solely 75 µm in a polyamide layer that is applied to the cone. That special coating not only improves the stiffness, but the cones inner damping as well. However, these stabilizing measures do not increase the moving mass. Compared to other subs the cone is even lighter, which not only leads to a lower total Q factor but also further improves the impulse response.

“Engineering at its best” in harmony with timeless elegance
Each BRAX product impresses with a puristic design and perfect workmanship in every detail - and of course the BRAX ML10 SUB is no exception! Its extremely linear magnet drive with precisely machined pole plates for lowest level of distortion, the large, multi-ventilated voice coil for maximum electrical power handling and the aerodynamically shaped and stable die-cast basket warrant for uncompromising bass reproduction at the very highest level.  


Of course, the ML10 SUB comes in a noble wooden box with its own serial number, which is recorded in a service database.

brax.png

 

Features

  • Exceptional stiff hand-scooped paper cone with unique “MicroSphere” coating consisting of micro ceramic hollow spheres embedded in a polymer layer offers best possible impulse response

  • Specially shaped rubber surround for long linear cone excursion

  • 2 x 2 Ohms dual voice coil with exceptional winding height for high linear excursion and lowest possible distortion

  • Optimized voice coil ventilation through large, mesh-protected holes in T-yoke and basket for almost zero compression effects and maximum heat dissipation

  • Specially developed, aerodynamically optimized and extremely solid aluminum diecast basket

  • Extremely powerful and precisely machined magnet system for highest magnetic flux linearity

  • Massive push-terminals for large wire gauge

 

Speclflcation

Power RMS / max. 

Impedance 

DC resistance 

Resonance frequency 

Mechanical Q factor

Electrical Q factor 

Total Q factor

Compliance

Equivalent air volume 

Force factor 

Efficiency 1 W / 1 m

Cone area 

Moving mass

Cone material 

Mechanical resistance 

Voice coil diameter

Voice coil winding height 

Max. linear excursion 

Outer diameter

Installation diameter

Installation depth

 

Recommended enclosure volumes  

Sealed box

Net volume 

Lower limiting frequency (-3dB) 

 

DSP setting highpass filter

P
Z

Re

Fs

Qms Qes

Qts

Cms

Vas

B*I

SPL

Sd

Mms

Rms

ø

Xmax

ø

ø

600 / 1200 Watts

2 x 2 Ω

2 x 1.9 Ω

34 Hz

7.78

0.55

0.51

265 μm/N

46 L

11.30 Tm

87 dB
346 cm²

83 g

Paper cone with “MicroSphere” coating consisting of micro ceramic hollow spheres embedded in a polymer layer

2.26 kg/s

65 mm

33 mm

+/- 12.5 mm

275 mm / 10.8"

235 mm / 9.3"

114 mm / 4.5"

 

 

28 L

43 Hz

Frequency: 32 Hz
Characteristic: “Self-define”
Q-Factor: 1.0

Anchor 1
bottom of page